I found the package 'etherwake' that could do the job if I'm ssh'ing to my openwrt router in order to launch the command. It generates the standard AMD Magic Packet format, optionally with a password included. Hello, I'm looking for a way to use WakeOnLan, from WAN, to wake up my desktop computer. Heres an example of a typical use: wakeonlan -i 192.168.1. the author is only aware of 2 implementations, one being ether-wake which uses. (Its a Perl script for waking up computers via Wake-On-LAN magic packets.) When installed, you can send a 'magic packet' from your Terminal to any device using its IP (Internet Protocol) and MAC (Media Access Control) address. It sounds from your answer that you might have found some info on bridged networking that predated the "official" (albeit preview) support that was added earlier this year. ether-wake is a program that generates and transmits a Wake-On-LAN (WOL) 'Magic Packet', used for restarting machines that have been soft-powered-down (ACPI D3-warm state). WakeOnLAN is the protocol name given to the so-called Magic Packet. I have not tried this myself (I keep meaning to), but see this blog post for some details. I recently switched two of my servers to motherboards with IPMI that support iKVM over HTML5. ago Wake on Lan is a motherboard function if it's waking up from shutdown. Important To use the old interface names you have to enable the pre-Stretch naming via boot config file. We want to force it through the eth0 rather than wlan0. That's about all it would take TapeDeck 2 yr. To wake up a PC simply use: etherwake -i eth0 AA:BB:CC:DD:EE:FF The (-i) interface is specified to push the magic packet via a correct interface. There's a new feature there that allows you to create a separate bridged interface in Hyper-V and use it with WSL2. Install etherwake and know the MAC address of your server's NIC. Because the Windows executable is running on the Windows network, it should still work fine, even when called from within WSL2.Īnother possible solution, since you are running Windows 11 (assuming it is Pro or higher), is to install the WSL Preview release from the Microsoft Store (or from the WSL releases page). An alternative opkg-package is etherwake Please see /etc/crontabs/root to. WSL2 is on a different Layer 2 network (running inside Hyper-V) than your other devices, so the WoL magic broadcast packet can't cross over from WSL2 to your physical device.īut through WSL Interop, we can at least call Windows processes from within WSL2, so assuming the Windows software you mentioned above has a commandline interface, you should be able to use it directly from WSL2. To Wake-on-LAN via the internet, click Add and choose IPv4, enter the MAC. That might provide the workaround to do it from within WSL2.Īs mentioned in the comments (although to use different terminology), WoL works on Layer 2 (see this answer). Most WoL hardware functionally is typically blocked. My Windows machine has no issue using WOL to wake my Linux machine when using a platform-dedicated software OpenWrt supports both Linux implementations for WoL etherwake and WoLs.
0 Comments
Leave a Reply. |